Paver sealing for Saint Johns homes
Paver Sealing in Saint Johns, FL
Pavers fading in Saint Johns? Get local help from Neptune Beach Paver Sealing. Call (904) 906-9979
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligations.
Paver sealing help in Saint Johns
Saint Johns sits in northwest St. Johns County, about halfway between downtown Jacksonville and downtown St. Augustine. Maybe your paver driveway looked sharp the day you moved in, and now the garage apron has gone gray, weeds poke through the joints and a green edge runs along the fence. A wash, new sand in the joints and a fresh coat bring the color back and leave the joints full. You can request a quote for a free estimate from an independent contractor, with no obligation.
This website does not do the sealing. It connects Saint Johns homeowners with a contractor, and that contractor comes out, measures your pavers, gives you a price and does the work. Have your subdivision name handy, since Durbin Crossing and RiverTown come with different questions. Call (904) 906-9979 to describe what you see, and there is nothing to pay for the estimate.
5 common paver problems in Saint Johns
Soft ground on the low side of the lot
The water district describes land around Julington and Durbin creeks as sandhill on the high spots, flatwoods lower down and swamp along the shore. USDA soil notes say flatwoods sand like the Myakka series can hold water within 18 inches of the surface for one to four months in most years. If your Saint Johns driveway sits on ground like that, the sand under it can stay soft and a corner can sink. Sealer will not lift it, which means that spot gets reset first.
Sprinklers that keep the pavers wet
St. Johns County sets watering days and times by address in parts of SilverLeaf that use reclaimed water, and in February 2026 it asked residents to stick to a once-a-week schedule. A zone that runs early can leave your pavers damp on the morning of the job. Sealer needs a dry surface, so look up your watering day before you book. Spray that hits the same strip every week is also worth aiming back onto the grass.
Green film along the preserve line
Saint Johns developers left a lot of woods standing. Durbin Crossing kept more than half of its land undisturbed, and SilverLeaf set aside almost 4,000 acres to the south. One paving industry article says moss and algae should not grow on pavers unless the area is heavily shaded, so green film tells you where the shade is. Check the edge of your patio closest to the tree line, where the shade sits longest.
Sealer layers from two different eras
Durbin Crossing broke ground in 2005, while RiverTown was still opening new sections in 2017. An older driveway in Saint Johns may carry coats from owners you never met, and water-based sealer cannot go over solvent-based sealer. A brand new driveway has the opposite problem. One Jacksonville paver company says to wait 30 to 60 days after installation before the first coat.
Joint sand that goes missing after storms
St. Augustine, the county seat, averages 50.6 inches of rain over 118 wet days a year. That is a lot of water running across a Saint Johns driveway and out to the street. When joints run low they get wider, soil settles in and weeds follow. A film-forming sealer can help hold new joint sand, so a driveway that keeps losing sand has a good reason to get a fresh coat.
Durbin Crossing, Aberdeen, RiverTown and the roads between them
Durbin Crossing covers 2,086 acres between Race Track Road and County Road 210, on land bought from the timber company Rayonier. Beazer, Ryland, Toll Brothers and other builders all worked there, so the paving at one house may not match the next street over. That matters when you want a patch of new pavers to blend in or a sheen that looks right beside a neighbor's. Note your builder, if you know it, when you request a quote.
Aberdeen covers 1,316 acres off Race Track Road, with homes set a short walk from its clubhouse and pools. RiverTown is a different kind of place, with about 3.5 miles of St. Johns River shoreline off State Road 13 and homes from 1,700 to more than 3,500 square feet. In the section called The Landings, homesites are 60 feet wide, so the pavers out front and out back both go into the count. If you live in either one, call (904) 906-9979 and give the contractor a rough size.
Cimarrone and Beachwalk are two more Saint Johns neighborhoods, and Ocean Palms Elementary serves the Beachwalk side. South of County Road 210, SilverLeaf is planned for up to 10,700 homes along St. Johns Parkway, starting with Holly Forest, Meadow Ridge and SilverLeaf Village. If your Saint Johns home sits in a planned community like these, ask the association about paver color and sheen before work starts. Once you know the rules, you can request a quote and pass them along.
Why Saint Johns chooses Neptune Beach Paver Sealing
You could call around and compare a long list of companies in St. Johns County yourself. This site exists so you do not have to. To try it, request a quote.
Free estimate
Tell us what you need in Saint Johns and a contractor who works in the area will look at the job and price it.
Local price range
Northeast Florida companies commonly publish $1.50 to $2.50 per square foot for clean, sand and seal, so you know the range going in.
Your choice of finish
Pick a natural matte look or a deeper wet look. The contractor can explain how each one will wear on your surface.
You decide
Get the price in writing and take your time. Nothing moves forward at your Saint Johns home until you say so.
Get Your Free Estimate in Saint Johns
Tell us about your pavers in Saint Johns.
Free, no obligations
Paver sealing pricing in Saint Johns
Expect a rate of $1.50 to $2.50 per square foot to clean, sand and seal, which is what Northeast Florida companies commonly publish. In Saint Johns, size is the big swing, since a 1,700 square foot RiverTown home and a 3,500 square foot one can carry much different amounts of paving. Multiply the length by the width of each paved area and you will have a number to check any quote against. To get your own figure, request a quote for a free estimate with no obligation.
Inside that range, a few things push the number. A patio along the preserve line may need more cleaning, a sunken corner needs repair before sealing, and a coat of unknown sealer takes extra work to sort out. A sunny driveway with full joints sits on the easier end. Call (904) 906-9979 and the contractor can tell you which of those apply to your Saint Johns home.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $450 to $750 |
| 600 sq ft | Two car driveway | $900 to $1,500 |
| 1,000 sq ft | Large driveway or pool deck | $1,500 to $2,500 |
| 1,500 sq ft | Driveway plus pool deck | $2,250 to $3,750 |
Math based on the $1.50 to $2.50 per square foot that Northeast Florida paver companies published as of November 2026. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.
How a paver sealing job works in Saint Johns
Look for dips and old coats
The contractor starts by walking your Saint Johns pavers, looking for sunken spots and checking what coat is already there. Low or lifted sections get repaired first, since sealing locks in whatever is underneath. If the house changed hands, ask the prior owner for a product name. Water-based sealer cannot go over solvent-based sealer, so that name saves a lot of guessing.
Wash with water, not brute force
Cleaning comes next, aimed at green film near the tree line and grit from the street. One trade guide warns that going past 3,000 PSI on standard concrete pavers can strip the surface for good, so more pressure is not better. A careful wash on a Durbin Crossing driveway should leave the faces clean and the edges whole. Keep pets and cars clear while the hoses are out.
Put the sand back
Washing pulls sand from the joints, so the joints get refilled before any sealer goes on. If storms have been carrying sand off your Saint Johns driveway for years, expect this step to take a while. Full joints give soil and weeds less room. Take a look before the sealer comes out, since the joints should be level and the paver tops swept clean.
Turn off the sprinklers and watch the sky
Sealer needs a dry surface, so timing drives this step. With 118 wet days a year at St. Augustine and irrigation on assigned days, a Saint Johns driveway can stay damp longer than it looks. Shut off any zone that reaches the pavers the day before and the day of the job. If storms roll in, a careful contractor will move the date.
Spray, back-roll and keep tires off
The sealer goes on in the finish you picked, and one Jacksonville paver company says pros typically spray it and then back-roll it so it settles evenly. A wet look shows scuffs sooner than matte, which is worth thinking about on a driveway with daily turns. Another Jacksonville company says foot traffic is usually fine within a few hours and cars need about a day. In a Saint Johns community with street parking rules, plan where the cars go before the day comes.
Complete paver services in Saint Johns
A complete sealing job has three stages. The surface is cleaned to remove algae, dirt and old residue. Fresh sand goes back into the joints, which helps keep pavers locked in place and gives weeds less room to grow. Once everything is dry, a water-based or solvent-based sealer goes on in a matte or wet look finish. To ask about any of these stages, call (904) 906-9979.
Driveways, walkways, patios and pool decks can all be sealed, and each takes different wear. A driveway deals with tires and oil. A pool deck deals with water and foot traffic. Shaded side yards tend to grow algae first. Let the contractor know how each area is used when you request a quote.
Sealer choice matters more than most homeowners expect. Water-based products are low odor and clean up easily, and can later be followed by either type. Solvent-based products typically give a higher gloss but generally have to be followed by solvent-based products. For help deciding, call (904) 906-9979.
Timing matters too. Sealer needs a dry surface, so a contractor will plan around rain and allow drying time after washing. If it has been a few years since your last coat, this is a good time to request a quote.
Questions to ask before you hire
- Which sealer will you use, and does it work with what is already on my pavers?
- Does your price include cleaning, joint sand and any repairs?
- How do you handle rain in the forecast?
- Can you show proof of insurance and any license the work requires?
- What happens if the finish turns cloudy?
- How long should I stay off the pavers once the sealer is down?
- When do you expect it will need another coat?
Why local matters in Saint Johns
Saint Johns has river lots and planned streets off Race Track Road, and the right questions change with the address. A contractor who works here asks Durbin Crossing owners about the age of the coat and RiverTown owners about their water. Someone from farther away may not know the difference. To reach a contractor who works this part of St. Johns County, call (904) 906-9979.
River weather is part of the job near RiverTown. News4Jax traced the historic St. Johns River flooding during Irma to days of northeast wind, heavy rain and runoff, and a lot that took water then deserves a closer look along its low side. A local contractor will ask about that before talking about sheen. If your Saint Johns home is near the river, you can request a quote and mention any past high water.
County water rules also shape the schedule. St. Johns County has assigned watering days by address in SilverLeaf, and its February 2026 shortage notice kept residents on one watering day a week. A contractor used to those rules will ask when your system runs before picking a day. If you have been wondering when to book, request a quote and there is no obligation to hire anyone.
How Saint Johns got its name
For years the Postal Service listed this part of St. Johns County under Jacksonville. In 2005 the local chamber of commerce pushed for a change, and a postal poll picked St. Johns over Fruit Cove, St. Johns Cove, River Oaks and Bartram. The push went by the slogan Anything but Jacksonville, and not everyone in Fruit Cove and Switzerland liked it. If your Saint Johns address still confuses people, you can request a quote and give the ZIP, 32259.
Daily errands now run through The Pavilion at Durbin Park, where a Walmart Supercenter arrived in November 2018. High school students here go to Creekside or Bartram Trail, and RiverTown has a riverfront park, a kayak launch and miles of trails along the St. Johns River. Durbin Crossing Park and Veterans Park are part of a 35-acre park system inside Durbin Crossing. To talk with a contractor who knows these Saint Johns landmarks, call (904) 906-9979.
Frequently Asked Questions
How much does it cost to seal pavers in Saint Johns, Florida?
Northeast Florida companies commonly publish $1.50 to $2.50 per square foot for the full job of cleaning, sanding and sealing. A Saint Johns total comes down to how many square feet you have and what shape the joints and old coat are in. Have the measured area written down so you can check the math.
Can I pressure wash my paver patio in Saint Johns?
Yes, but go easy on the pressure. One trade guide says going past 3,000 PSI on standard concrete pavers can strip the surface for good. Washing also pulls out joint sand, so a Saint Johns patio needs new sand before it gets sealed.
What do professionals use to seal pavers on a Saint Johns driveway?
Two kinds cover most jobs, an acrylic that forms a film and a silane or siloxane that soaks in. A film coats the surface and helps bind the joint sand, and a penetrating sealer sinks into the paver without changing how it looks. Ask for the product name and keep it, because water-based sealer cannot go over solvent-based sealer.
Is it better to spray or roll paver sealer?
Do both, in that order. One Jacksonville paver company says the spray gets even coverage and the roller pushes sealer into the joints so it does not puddle. Using only a roller can leave lap marks, and using only a sprayer can lay it on too thick.
How long do cars stay off a freshly sealed driveway in Saint Johns?
Plan on about a day. One Jacksonville company says people can usually walk on it within a few hours and cars need longer, depending on the sealer and the weather. If your Saint Johns association has street parking rules, check them ahead of time.
How soon can new pavers be sealed in a newer Saint Johns neighborhood?
Wait 30 to 60 days after installation, the span one Jacksonville paver company gives. Ask the builder what, if anything, went on at closing, since that changes what can go on next. Keep that answer with your closing papers for the next owner.
Will sealing fix a sunken corner on my Saint Johns driveway?
No, that corner needs repair before any coat goes on. Sealing locks in whatever is there, so it would only preserve the dip. Flatwoods ground that holds water is the kind of spot to check after a long rain.
Do I need my association's approval to seal pavers in Durbin Crossing or RiverTown?
Check with your association first, because rules differ by community. Ask about color, sheen and where the contractor can park. Getting a yes in writing before the work starts saves trouble later.